FAQ of Control CARD

Archive of posts published in the category: FAQ of Control CARD
Nov
29

If the sending card have no Green lamp flashing, how to do?

clone Mode

If the sending card have no Green lamp flashing, how to do? Generally, if the green Lamp of the card not work or no flashing, it means the sending card does not have input video source. We can use the following ways to…

Sep
10

How to linsn RCG intelligent setup

intelligent_setup

Many customers need to configure Linsn receive cards, before use the LED Display. But they do not know how to do it. Here to share the Linsn intelligent setup manual, Hope to help you!  PDF File: linsn-rcg-intelligent-setup

Sep
7

How to upgrade Linsn receiver Card’s program

Linsn_Receiver_upgrade

Enter the hardware interface settings{ Option > software setup > (input “Linsn” password”168″) > receiver > (input “cfxoki”) }. In the receiving card input ‘cfxoki’ pop-up card upgrade interface. Load the “***.bin” file to programming. Attention: The upgrade program must upgrade with sending…

Sep
7

How to cascate of two TS802

4

Hardware ready: 1, a DVI cable (DVI cable a turn two lines) 2, 2 linsn 802 send card 3, a ten-pin cable   the hardware connection with ten pins traversing cascading up two to send a card, as shown in Figure 1.2 each…

Jan
15

How to Change the PSD100-WIFI Route‘s Language

Novastar_WIFI_2

When you connect the Novarstar PSD100-WIFI card. and login 192.168.10.1 , you will found the default language is Chinese. With this two photo , you can change it to English. You need other Language, sorry, it’s have not. Just see this two Photo.…

Dec
15

Which LED Display HUB will I need?

HUB_need_2

Which LED display HUB will I need? Usually a LED display hub card is used to connect LED module and receiver card. Then, What’s hub card? So Which HUB will be the correct one for my need ?

Dec
15

What’s LED Display Hub Card?

LED_Screen_HUB75B

Usually a LED display hub card is used to connect LED module and receiver card. Then, What’s hub card? The HUB card used in LED display is a passive HUB. It’s designed for LED receiver card’s signal distribution,and hub card can help the signal distribute in 4 ,6, 8 or 12 output. In this way,a reciver card can be connected to many rows of LED modules.

Dec
7

How to use EX901 and EX902 multifunction Card

Item_of_EX901

Last week, one of my client put a question to me about the using of EX901, he is very upset for the thing. Then I contacted our engineer at once to help him solve the question. He really appreciated us and our company and gave us a highly praised. Now we share the solution to you. Please see the followings:

Nov
24

What is the difference between rv908 and rv901

Linsn_RV908H_receiver_card_3

RV908 has twelve HUB75 interface, can only be used with HUB75 interface module. RV901 has no HUB75 interface, but can connect with the HUB card, so can be used in all kinds of interface definition module.

Nov
24

How to judge sending card and receiving card is broken?

Linsn_ts802_major_board_2

First Visually observe whether there is a lack of components, damaged, if there is a short circuit chip burn through, whether by the lightning. Judging from light, red light is power lamp, green light is a signal lamp. The red light can be…