Today is the opening day of LEDCARD in new year! From today we get into normal working time.

We add some Meanwell 12V and 24V Power

If the sending card have no Green lamp flashing, how to do?
Generally, if the green Lamp of the card not work or no flashing, it means the sending card does not have input video source.

We can use the following ways to find the reason:

The latest news from VDWALL: LVP603 and LVP603S from now on has been discontinued, But there is a part of stock products,but new products will no longer be produced.

1 (blue) this is the LED module driver chip, is generally MBI5020 MBI5024… Mainly used to control the vertical LED column
2 (green) this is Manager IC Line. Is generally 4953 LED Driver CHIP each chip to control the 2 lines or 4 lines

3 (yellow) this is a signal amplifier chip, the general is 74HC138
So。

As the recently, car screen especially popular, our own R & D design of vehicle control card With a very affordable price in full color.

Many customers need to configure Linsn receive cards, before use the LED Display.
But they do not know how to do it.
Here to share the Linsn intelligent setup manual, Hope to help you!  PDF File: 

Enter the hardware interface settings{ Option > software setup > (input “Linsn” password”168″) > receiver > (input “cfxoki”) }.
In the receiving card input ‘cfxoki’ pop-up card upgrade interface. Load the “***.bin” file to programming.

Linsn_Receiver_upgrade

Hardware ready: 1, a DVI cable (DVI cable a turn two lines) 2, 2 linsn 802 send card 3, a ten-pin cable the hardware connection with ten pins traversing cascading up two to send a card, as shown in Figure 1.2 1 each TS802 have a red button, press the key set one to 1, set another card key unchanged. As in Figure 2.